Facial tissue has become one of the fastest moving paper categories in the Middle East. National localization programmes in Saudi Arabia and the UAE, a hospitality pipeline that keeps adding hotel rooms in Riyadh, Jeddah, Dubai and Doha, and steady growth in household hygiene spending have pushed retailers to look for regional supply instead of container imports. For a converter, the practical question is no longer whether a facial tissue production line makes sense, but which configuration survives a 50 °C summer, a 380 V/50 Hz grid and a service network that sits four time zones away.
A facial tissue production line is a chain of machines, and each link sets the ceiling for the ones behind it. The table below shows the modules a converter normally installs for 2–3 ply V fold facial tissue.
| Module | Typical specification | What it controls |
|---|---|---|
| Unwinding stands | 1–5 units, 2100 mm parent roll width | Ply count and paper splicing downtime |
| V fold folding machine | 100–130 m/min, 200 mm or 210 mm folded size | Output speed and interfold accuracy |
| Log saw | 200–360 cuts/min, 500–610 mm round knife | Cut accuracy and knife cost per tonne |
| Soft pack packing machine | 140–160 packs/min, PE or BOPP film | Retail pack quality and film consumption |
| Bundle or carton packing | 10–15 bundles/min, pre-made bag or heat seal | Pallet presentation and distributor acceptance |
| Optional embossing and printing | Steel to rubber or steel to steel, 2–4 colour flexo | Private label value and shelf differentiation |
The folding machine usually decides the line rating. A 130 m/min V fold head converts to roughly 100–140 retail packs per minute depending on sheet count and ply, and the packing machine must be sized above that figure so the folder never waits.
Most Gulf industrial parks run 400 V/50 Hz three phase, Saudi plants commonly 380 V/50 Hz, and some older facilities still distribute 220 V. Confirm the plant voltage before the order is released, not after the container arrives. Motors and inverters must be rated for the local grid, and insulation should be Class F or H rather than the Class B specification often quoted for temperate markets.